There was a lot of effort required to program the frame geometry into the software that drives the CNC router. It…

When there is so much space in a “head”, it might as well get called a bathroom. On most other boats,…

I found more photos of the hull rollover. It was the hottest day of the summer, going well over 40 degrees.…

The bridgedeck is the floor of the cabin that joins the 2 hulls. It is created from 6 sheets of 12mm…

Now looking like a boat. Hulls have been leveled and straightened. We have been using a laser level, spirit level and diagonal distances…

Yesterday, we had 21 visitors help us roll the two hulls. Thanks, everyone! The job went smoothly, with no real issues.…

I am still not sure about the outboard motors to use, but I am sure that I want more power than…

We didn’t start this hull till the end of November. There was a weekend of work lost, when we had the…

Completed the skinning of the port hull this morning. After fairing the chines, there is still the keel to add, shaping…

IMAG0234, a photo by SeeBeeZee on Flickr. More blood! Came out from under the hull, and forgot to look up before…

Working on the second hull is both exciting and boring at the same time. It is exciting that progress is so…

We have changed the sheeting, again, on the bow of the port hull. The objective of the change is to reduce,…